# ESQ-1 panel board voltages

**URL:** <https://forums.syntaur.com/t/esq-1-panel-board-voltages/5714>\
**Category:** Synth Repair\
**Created:** [May 14, 2023, 11:10pm UTC](https://forums.syntaur.com/t/esq-1-panel-board-voltages/5714 "2023-05-14T23:10:26Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![scottmetoyer](https://forums.syntaur.com/user_avatar/forums.syntaur.com/scottmetoyer/32/1237_2.png) [@scottmetoyer](https://forums.syntaur.com/u/scottmetoyer)\
**Post date:** [May 14, 2023, 11:10pm UTC](https://forums.syntaur.com/t/esq-1-panel-board-voltages/5714/1 "2023-05-14T23:10:26Z")

</div>

I’m trying to diagnose a few bad buttons on a metal-case Ensoniq ESQ-1 (the stop button, Bank Select button #4, and soft button #4) that suddenly stopped working.

I see they all share a trace on the panel board, and when I measure voltage on that trace to ground it reads around .2 volts and then slowly drops in voltage as I watch. Measuring voltage elsewhere on board shows 4.7, 3.7v, or 0 but nothing else shows low voltage with a slow drop like that.

Does anyone know what voltage I should be reading at these buttons?

---

<div class="post-metadata">

**Author:** ![scottmetoyer](https://forums.syntaur.com/user_avatar/forums.syntaur.com/scottmetoyer/32/1237_2.png) [@scottmetoyer](https://forums.syntaur.com/u/scottmetoyer)\
**Post date:** [May 15, 2023, 6:23pm UTC](https://forums.syntaur.com/t/esq-1-panel-board-voltages/5714/2 "2023-05-15T18:23:15Z")

</div>

Got a really helpful email reply back from Rainer Buchty so I want to share for the next person:

> The row lines are input lines, so technically they should exhibit the  
> pullup voltage in inactive state and fall down to zero (or at least  
> logical low) with a pressed button.
> 
> However, the latter you wouldn’t really be seeing with a voltmeter, but  
> rather an oscilloscope.
> 
> Assuming that no button is pressed, seemingly something is bringing that  
> input down that shouldn’t.

I disconnected the panel board completely and checked voltage directly at the row 7 pin on the 65003 display board chip and saw the same .2 volts, so it does look like that IC is bad. Off to find a replacement!
