Juno-60 Hold button/key Install

Going to order the Hold button here and wanted to know how difficult to install, looks pretty straightforward, just push the button into the square opening? Or is there more involved?

Also, just noticed my Arpeggio & Key Transpose buttons are reversed so will need to remove those and reinstall in their proper positions. Just don’t want to ruin anything by doing it wrong or using a wrong tool (if needed).

Thanks for any suggestions!

It’s just a matter of desoldering the old switch from the circuit board, then soldering the new one in its place. Just make sure you don’t pull up any traces when desoldering and removing the original switch.